5 How to to avoid "snowing" display while graphics operations

Contents of this section

For cards with S3 Vision864 chip there is a automatic correction which depends on the pixel clock and the memory clock MCLK at which the S3 chip operates. For most clock chips this value can't be read (only the S3 SDAC allows reading the MCLK value so far), so this value has to be estimated and specified by the user (the default is 60 MHz).

With the new `s3MCLK' entry for your XF86Config file now you can specify e.g.

 s3MCLK 55
 

for a 55 MHz MCLK which will reduce snowing. Smaller MCLK values will reduce performance a bit so you shouldn't use a too low value (55 or 50 should be a good guess in most cases).

Below is a small shell script which might be useful to determine the approximate value for MCLK (about +/- 1-2 MHz error). Before running this script you have to add the line

 s3MNadjust -31 255
 

to the device section in your XF86Config file and restart X Windows. With this option (which is for testing and debugging only) you'll get lots of disastrous display flickering and snowing, so it should be removed again immediately after running the test script below.

Running this script will use xbench and/or x11perf to run a test to determine the MLCK value, which is printed in MHz. Up to 4 tests are run, so you'll get up to 4 estimates (where the first might be the most accurate one).


#!/bin/sh

exec 2> /dev/null

scale=2

calc() {
  m=`awk 'BEGIN{printf "%.'$scale'f\n",'"( $1 + $2 ) / $3; exit}" `
  [ -z "$m" ] && m=` echo "scale=$scale; ( $1 + $2 ) / $3" | bc `
  [ -z "$m" ] && m=` echo "$scale $1 $2 + $3 / pq" | dc `
  echo $m
}

run_xbench() { 
  r=` ( echo 1; echo 2; echo 3; echo 4 ) | xbench -only $1 | grep rate `
  [ -z "$r" ] && return
  cp="$2 $3"
  set $r
  calc $3 $cp
}  

run_x11perf() {
  r=` x11perf $1 | grep trep | tr '(/)' '   ' `
  [ -z "$r" ] && return
  cp="$2 $3"
  set $r
  calc `calc 1000 0 $4` $cp    
}

run_x11perf "-rect500 -rop GXxor"     3.86  5.53  #  0 1  #    4.11    5.52  #
run_xbench invrects500                4.63  5.48  #  0 1  #    4.69    5.48  #

run_x11perf "-rect500 -rop GXcopy"  -16.42 13.90  #  0 1  #  -14.99   13.88  #
run_xbench fillrects500              -7.81 13.57  #  0 1  #   -8.53   13.58  #

exit

$XConsortium: S3.sgml,v 1.6 95/01/27 16:14:30 kaleb Exp $
$XFree86: xc/programs/Xserver/hw/xfree86/doc/sgml/S3.sgml,v 3.12 1995/01/28 16:02:17 dawes Exp $

Next Chapter, Previous Chapter

Table of contents of this chapter, General table of contents

Top of the document, Beginning of this Chapter