Before you can install Linux on your hard drive, you must partition your
drive, and put a file system on it.  Roughly, this entails:

 - Create a Linux/Minix partition with "fdisk" on your hard drive and reboot.
 - Make a file system on the partition with "mkfs" (or "mkefs", see below).
 - Use "doinstall /dev/PART", where PART is your partition, to start 
   the installation.  For example "doinstall /dev/hda2".

This last step will ask you to put a formatted floppy in the drive
so that BOOT DISK can be prepared for you, so have one ready ahead of time.  
When the installation is complete, and you reboot from this floppy, you 
will be using Linux from your hard drive.

Before you begin, however, you may wish to type "menu" and browse the
Instructions submenu.  But make sure you exit "menu" before you start
the install process.  You can also print files from there using "P",
or you can use "cat README > /dev/lp1" or "cat README > /dev/lp2".

Your first task after the base install is done, should be to make backup
copies of all of your disks  (Look in the "User Commands" menu).
In fact, you should make sure all disks are write protected first,
before you start the installation.  After the install, you can log on as "root".

PS:
Note, although you can use the Extended FS type, it is not recommeneded
(read as not tested), and is subject to change.

**************** EXAMPLE PARTITIONING PROCEDURE **************************
/# fdisk
 
Command (m for help): n
Command action
   e   extended
   p   primary partition (1-4)
p
Partition number (1-4): 2
First cylinder (500-977): 500
Last cylinder or +size or +sizeM or +sizeK (500-977): 977
 
Command (m for help): t
Partition number (1-4): 1
Hex code (type L to list codes): 81
 
Command (m for help): v
Command (m for help): p
 
Disk /dev/hda: 5 heads, 17 sectors, 977 cylinders
Units = cylinders of 85 * 512 bytes
 
   Device Boot  Begin   Start     End  Blocks   Id  System
/dev/hda1           1       1     499   20000    4  DOS
/dev/hda2           1       1       7   30000   81  Linux/MINIX

Command (m for help): w
reboot now before doing anything else
/#
...<after the reboot>
/# mkfs /dev/hda2 30000
/# doinstall /dev/hda2
