     Alternate Tile Set for Mah Jongg

Tile set name: SCHEMATK.TIL
Subject: Schematic symbols used with PADS-LOGIC schematic drafter
Created by: Thomas Taylor

PADS-LOGIC is a program which allows a printed circuit board designer to
create a circuit representing the desired components.  This circuit is then
used as input to another program in which the actual printed circuit board
layout is accomplished.  The following list of symbols are ones which I use
in my system and are mostly commonly used representations.

   The tiles are:

1.  Switch,SPST               18. N type MOSFET
2.  Switch,DPST               19. P type MOSFET
3.  Switch,Normally Open PB   20. NPN transistor
4.  Switch,Normally Closed PB 21. PNP transistor
5.  Coil                      22. Diode or rectifier
6.  Transformer               23. Potentiometer
7.  Relay, SPDT               24. Zener diode
8.  Connector                 25. Operational Amplifier
9.  Off Page connector        26. Silicon Controlled Rectifier
10. NAND gate                 27. +5 volt power
11. NOR gate                  28. Circuit ground
12. Buffer (non-inverting)    29. Earth ground
13. Inverting buffer          30. Chassis ground
14. AND gate                  31. Resistor
15. OR gate                   32. Light Emitting Diode
16. P type Junction FET       33. Capacitor
17. N type Junction FET       34. Battery


35. Microphone      \
36. Speaker         | first wildcard
37. Meter           | set
38. Personal Logo   /

39. Square Wave     \
40. Triangle Wave   | second wildcard
41. Sine Wave       | set
42. Sawtooth Wave   /

