
    ====>>>> Key Commands available in Instrument Panel Screen <<<<=====     1

          Keys followed by + or - will allow you to repeatedly press
          + or - for the same effect until you press another key.

     Ctl-A     Toggle Autopilot between NAVLOCK and HEADING modes.

     Ctl-M     Go to Map Mode

     Enter     Reset Time Compression to 1x

     Ctl-N     cycle Day/Dusk/Night

     Esc       abort current function, back out of menu,
               show main menu if none visible.

     Space     Toggle Brakes on/off

     '         Change Fuel Selector

     /         Toggle Brakes on/off

     1-9       Menu Options

     A         Toggle Autopilot On/Off

     F+        Extend Flaps  1 notch
     F-        Retract Flaps 1 notch

     G         Toggle Gear

     H+        Increase Carb Heat
     H-        Decrease Carb Heat

     K         Calibrate Joystick

     M+        Lean Mixture        
     M-        Rich Mixture

     P         Toggle Pause

     S         Toggle Engine Sound

     T         Cycle Stop Watch Timer (Stop, Reset, Start)

     [         Close Cowl Flaps
     ]         Open Cowl Flaps

     <>        (But UNshifted, so comma and period) Move AutoPilot Bug.

     `         Toggle Menu


                                                                             2

     Alt-A     Next Autopilot Altitude Hold mode (OFF/ALT/ILSLOCK)
     Alt-B     Toggle Beacon (Strobe)
     Alt-D     Move Autopilot Bug
     Alt-F     Toggle Fuel Pump
     Alt-G+/-  Increase/Decrease Directional Gyro setting
     Alt-K+/-  Increase/Decrease Altimeter Setting (Kollsman window)
     Alt-L     Toggle Landing Lights
     Alt-M+/-  Next Magneto Setting
     Alt-N     Toggle Nav Lights (wing red and green lights)
     Alt-P     Toggle Pitot Heat
     Alt-S     Start Engine
     Alt-T     Toggle Taxi Lights
     Alt-X     Toggle Master Electric
     Alt-Z     Toggle Alternator

     F1        VOR1 Decrease OBS
     F2        VOR1 Increase OBS
     Ctl-F1    NAV1 Decrease Freq
     Ctl-F2    NAV1 Increase Freq
     Shift-F1  Toggle NAV1 on/off
     Shift-F2  Toggle NAV2 on/off
     Alt-F1    Swap NAV1 Freqs
     Alt-F2    Swap NAV1 Freqs
     

     F3        VOR2 Decrease OBS
     F4        VOR2 Increase OBS
     Ctl-F3    NAV2 Decrease Freq
     Ctl-F4    NAV2 Increase Freq
     Shift-F3  Toggle ADFR1 on/off
     Shift-F4  Toggle ADFR2 on/off
     Alt-F3    Swap NAV2 Freqs
     Alt-F4    Swap NAV2 Freqs


     F5        ADF1 Decrease Card
     F6        ADF1 Increase Card
     Ctl-F5    ADFR1 Decrease Freq
     Ctl-F6    ADFR1 Increase Freq
     Shift-F5  Toggle COMM1 on/off
     Shift-F6  Toggle MARKERS on/off
     Alt-F5    Swap ADFR1 Freqs
     Alt-F6    Swap ADFR1 Freqs

     F7        Retract Flaps
     F8        Extend Flaps
     Ctl-F7    ADFR2 Decrease Freq
     Ctl-F8    ADFR2 Increase Freq
     Shift-F7  Toggle TRANSPONDER on/off
     Alt-F7    Swap ADFR2 Freqs
     Alt-F8    Swap ADFR2 Freqs
     

                                                                             3

     Home      Nose Down Trim
     End       Nose Up Trim
     
     Up        Nose Down Elevator
     Down      Nose Up Elevator
     
     PgUp      Increase Throttle
     PgDn      Decrease Throttle

     Grey +    Increase Prop Pitch
     Grey -    Decrease Prop Pitch

     Numeric 5 Center Ailerons, Elevator, and Rudder

     Numeric 0 Left Rudder
     Numeric . Right Rudder
     
     Alt-1      Set Time Compression
     through    to number
     Alt-9    

           ====>>>> Key Commands available in Map Screen <<<<=====           


     Tab       Highlight Next Measure Line

     Ctl-J     Select Closest Flight Path Dot

     Enter     Center/Redraw Map

     Ctl-R     Make Closest Runway End to Map Cursor Active Runway

     Esc       Abort Current Measure Operations

     *         Add Waypoint at Map Cursor Positon

     @         Air Config

     #         Ground Config

     -         Decrease Map Cursor Movement Amount
     +         Increase Map Cursor Movement Amount
     
     B         Enlarge Current Zoom Slightly


                                                                             4

     C         Change Aircraft Location (Current, Ground, or Air Config)

     D         Draw Path of Flight slowly (to review sequentially)

     E         Erase Path of Flight, Measure Line or Lines.

     G         Goto Location (Do Not Move Aircraft)

     H         Home Map Cursor (return to Aircraft Location)

     I         Toggle Additional Info mode (Frequencies, ILS Arrows, etc.)

     L         Toggle Labels only

     M         Measure Line Toggle

     N         Return to Normal Zooms (After S and B commands)

     O         Output Map to Epson Printer

     P         Toggle Profile

     R         Toggle Radial Line Draw

     S         Reduce Current Zoom Slightly

     Lft/Rght  Move Map Cursor
     Up/Down
     Home/End  (diagonally)
     PgUp/PgDn

     F1-F10    Zoom

     Ctl-F1-
     Ctl-F10   Zoom Profile

     Ctl-Left
     Ctl-Right Scroll Profile

