
start <servers...>

     Start the specified server. Do a 'start ?' for a list of
     available servers.

     Servers often take an argument which specifies an alternate
     port number from which to listen.  Example:
            start callbook [port#]               Default port: 1235
     Default port numbers are listed in socket.h.

    Exceptions:

     start tip iface [modem | terminal] [timeout_secs]

      starts a mailbox server which listens for connections on <iface>.
      If <modem> is used, CD (carrier detect) must be asserted before a
      connection is recognized.  A <timeout> value specifies how many
      seconds of inactivity must occur before a disconnect is initiated.


    A tip about using the tip server to provide async dialup access to
    Jnos:  the following commands demonstrate one way to set it up.

     # source this file to configure COM1 for dialup access to JNOS
     attach asy 0x3f8 4 ax25 dialup 2048 256 9600
     #
     ifconfig dialup descrip "dialup access"
     param dialup up
     # Send any desired config cmds here, eg, answer phone on 1st ring
     comm dialup "atz e0 s0=1"
     pause 2
     #start tip dialup terminal 360
     start tip dialup modem 360
     # If the modem obeys DTR (must be asserted to answer the phone)
     # the modem might be permed with S0=1, and then the answering could
     # be controlled by param dialup up, param dialup down, commands
     # possibly done daily by a repeating at command...
