/*
 * INSTALL.DAT
 *
 * Project: ECG(R) Semiconductors, MASTER GUIDE, CROSS REFERENCE
 * Version: 1.0
 *
 * This INSTALL.DAT was automatically generated by DDB
 */

@DefineProject
	@Name = "ECG Semiconductors, INSTANT CROSS, Master Guide"
	@Version = "1.01"
	@Immediate = 1
	
	@Subdir = "\\ECG"
	@OutDrive = Z
	@Requires @HardDisk
@EndProject

@Display
	@Cls

	The installation program used to install 
	@Name 
	INSTALL, is licensed software provided by 
	Knowledge Dynamics Corp, PO Box 1558, Canyon Lake, 
	TX 78130-1558 (USA). INSTALL is Copyright (c) 1987-1991 
	by Knowledge Dynamics Corp which reserves all copyright 
	protection worldwide. INSTALL is provided to you for the 
	exclusive purpose of installing 
	@Name. 
	Philips ECG is exclusively responsible for the support of 
	@Name, 
	including support during the installation phase. In no 
	event will Knowledge Dynamics Corp. be able to provide 
	any technical support for Philips ECG.
  
	@Pause
@EndDisplay

@Display
	@Cls

	This program will install:

	@Name Version @Version

	on your computer system and verify the integrity of the
	distribution disk(s).  You may press the [Esc] key at any 
	time to abort the installation.

	INSTALL will ask you several questions about your computer
	hardware. Each question has a default answer.  If the default 
	answer is correct, press the ENTER key in response to the 
	question. Otherwise, type the answer and then press the 
	ENTER key.

	If you make a mistake while typing, press the BACKSPACE key
	and then retype the answer.

	@Pause
@EndDisplay

@GetOutDrive
	@Suppress A
	@Suppress B
	@Cls
	On which disk drive do you wish to install 
	@Name?













@EndOutDrive

@GetSubdir
	@Cls
	Now you need to specify the disk destination subdirectory.  The
	subdirectory is the location on your disk where the 
	@Name 
	system will be installed. If you don't know what a "subdirectory"
	is, you probably need not worry about it, and should enter "\" for
	the next prompt (don't type the quote characters).

	If you are using a subdirectory system, and the DOS PATH command,
	and you install 
	@Name
	in the @Subdir subdirectory, you will probably want to modify the 
	PATH so that it includes the subdirectory @Subdir in addition to 
	the current subdirectories.


	@Prompt = "Which subdirectory ([Enter] = @Subdir) ?"
@EndSubdir

@DefineDisk
	@Label = "Disk #1"
	@BeginLib ECG.001
		@F 0 @S 116002 @O ECGLIB.GXL
		@F 1 @S 179575 @O ECG4.FLE
		@F 2 @S 28214 @O ECG3.FLE
		@F 3 @S 116000 @O ECG2.FLE
		@F 4 @S 2829766 @O ECG1.FLE
	@EndLib
@EndDisk

@Chain("Disk #2")

/* end-of-file*/