Fiber Etching OR How To DO Cutwork W/O Scissors!

Purchase and postion appliques to fabric.
Iron on appliques.
Put fabric on embroidery hoop to raise surface from table and
make easier application of liquid Fiber Etch.
Squeeze from bottle, Fabric Etch  on areas of material you want to remove.
Dry.
Iron for 30 seconds w/medium heat iron. When brownish poke a little
with finger to start opening.
Take to sink and run under steady stream of water.
Voila! Cutwork!

Only removes natural filber, so if done on 50/50 poly/ctn
will make a thin fabric, leaving design where Fabric Etch was NOT put.

Ordering Info, if you wish to purchase kit from Aleen's.
52094B Kit 19.90 for 2 bottles and instruction books

Aleen's
Fiber Etch G-294
PO Box 9500
Buellton, CA 93427
1-800-825-3363