------------------
 Making the X
------------------

One of the few rules in counted cross stitch is that all the stitches should
go in the same direction.  It doesn't matter if the bottom half goes "/" and
the top goes "\", or vice versa.  Just make sure that _every_ stitch in the
project is done the same way.  (And to be perfectly honest, there are
exceptions to this rule, such as 3/4 stitches.)

The direction a person first learns to stitch seems to be a regional thing.
The only reason it _might_ be of importance is if you choose to do a very
complex chart from another country.  Some complex charts with many fractional
stitches or other embroidery stitches exhibit a subtle bias, assuming that the
X's will be done a particular direction.

Stitchers who use the traditional method complete each X as they go:

      XXXXXXXX

Stitchers who use the Danish method do the bottom stitches first, and complete
the X's as they return:

      /////XXX

Many people use a mix of the two methods.  They may use the Danish method for
most stitches, but do the occasional isolated stitch as a complete X.  Another
school recommends doing rows with the Danish method and columns with the
traditional method.  This causes the thread on the back to make vertical
lines.

Apparently, some antique samplers which were done in the traditional method
survive today because the X's hold the fabric together.  The "one-X-at-a-time"
approach works well when stitching over one thread, rather than the usual two,
as it helps stop the thread from disappearing behind the fabric.

Many people find the Danish method to be faster, and to result in less
confusion about current location.

Choose a method which you like, preferably one which results in neat backs.
While a neat back isn't _required_ for a good looking front, it usually helps.

