   The following settings were used to configure my ATI 9600 ETC/e and
   Wildcat 2.5s...there may be room for improvement, but it will connect
   at V42/V42bis and below without any problems (so far).
   Paradise Lost BBS- Tucker Ga. 404-934-6811 H. Few (SysOp)

   This file was created using WCexport.exe


                              Modem setup part 1

   Maximum number of seconds to wait for carrier ...................... 30
   Modem reset string ..............................[ATZ0                ]
***Modem startup string #1 .....[AT&F2&U1                                ]
   Modem startup string #2 .....[AT S0=0 S38=0 E0 V0 W2 &D3 &C1 &B1      ]
   Modem startup string #3 .....[AT&W0 &Y0                               ]
   Reinit after every call .....[AT S2=255                               ]
   Modem off-hook string .....................................[ATH1      ]
   Modem on-hook string ......................................[ATH0      ]
   Modem delay #1 ................................................... 3000
   Modem delay #2 ................................................... 2000
   Modem delay #3 ................................................... 3000
   Number of seconds to delay before displaying prelog file ......... 1500
   Initialize your modem at which baud rate ......................... 38400
   Lock the DTE setting at the initialized baud rate ................... Y

*** NOTE: The &U1 disables data compression....this will speed .zip file
    transfers somewhat, but is optional.

                              Modem setup part 2

   Answer phone using ........................................ Ring Detect
   Determine baud rate using ................................ Result Codes
   Numeric code for 300 baud non-reliable .............................  1
   Numeric code for 1200 baud non-reliable ............................  5
   Numeric code for 1200 (v.22) baud non-reliable ..................... 99
   Numeric code for 2400 baud non-reliable ............................ 10
   Numeric code for 9600 baud non-reliable ............................ 12
   Numeric code for 300 baud reliable ................................. 99
   Numeric code for 1200 baud reliable ................................ 22
   Numeric code for 1200 (v.22) baud reliable ......................... 99
   Numeric code for 2400 baud reliable ................................ 23
   Numeric code for 9600 baud reliable ................................ 35
   Does your modem support CTS/RTS flow control ........................ Y
