HOW TO PRINT A GEOWRITE DOCUMENT ACROSS A NETWORK

Note: It is not currently possible to print your geowrite/geodraw document across a network. Hopefully this situation will change soon and you'll be able to treat your GW document as you would any other word processing or DTP file and follow the normal procedures for saving and printing that you use on your computer network.

For future reference, to send a document to a printer over the Novell network, use the following command:
CAPTURE L=1 (or lpt#) Q= QueueName TI=10 NB NFF
Where:
L= the LPT#
Q= the name of the print queue you will send the doc to
TI= timeout in seconds that will signal end of print job <in this case, TI=10 means a print job is done when no data has been transmitted for 10 seconds)
NB= no banner (or title page for print job)
NFF= no formfeed following printjob

Note: Some smaller Novell networks use Printer numbers rather than Queue names. If this is the case, replace Q=QueueName with P=1 (or whatever the printer number may be).

IMPORTANT: Be sure you set up GeoWrite for the printer you will be sending the document to. If you will be sending your document to an HP Laserjet, set up GeoWrite for an HP Laserjet, if you'll be printing to an Epson LQ2550, set up GeoWrite for an EpsonLQ2550, etc. If your network has more than a single print queue, determine which printer is serving the print queue you will be using and setup GeoWrite for that printer.