
  ---------------------------------------------------------------------------
        deltaComm Development, Inc., PO Box 1185, Cary, NC  27512  USA

         (919)-460-4556 voice, (919)-460-4531 FAX, (919)-481-9399 BBS

          Telix Copyright (C) 1986-1995 by deltaComm Development, Inc.
  ---------------------------------------------------------------------------

 February 1st, 1995 --

       This minor patch file only needs to be used by callers to deltaComm
       Online, and only by callers who are using v1.01c. It will stop the
       automatic update system from asking you to download a patch file you
       don't need (v1.01c [registered] as originally released has a one-byte
       error that makes it think it is v1.01b, and thus still needs to be
       offered an update when it does not).

       To apply this patch, please follow the directions below precisely:

         1) Place the files PATCH.EXE and PATCH.RTP in the same directory that
            you keep TELIXR.DLL.  Exit Windows.  This patch program MUST be
            run when Windows is not loaded.

         2) Run the PATCH.EXE program. Your screen will look somewhat like the
            following, but may differ depending on the revision of Telix you
            are patching (the patch program may patch more files than are
            shown in this example) :


           PATCH  Version 2.01 - .RTPatch(R) Software Update System
       (C) Copyright Pocket Soft, Inc., 1991-1994.  All Rights Reserved.
                     < Pocket Soft, Inc.  (713) 460-5600 >



 Processing Patch File 

Applying UPDATE File Patch for 'TELIXR.DLL'

    Updating ...
    File successfully Updated!
    Deleting Old File

 Patch File Processing Complete 



         3) The resultant copy of TELIXR.DLL will be the latest release, and
            may be immediately used.

------------------------------------------------------------------------------

          Q: I get the following error message when applying the patch:

             error ept0036: Original file not found. However, a file of the
                            same name was found. No update done since file
                            checksums do not match.

          A: PATCH was unable to locate an exact match for the original file
             to be updated. It is likely that you are trying to apply this
             patch to a version OTHER than the registered v1.01c. If you think
             you may be patching the wrong file, or if you are certain that
             you are patching the right file, please contact Technical Support
             at (919) 460-4556 if this message persists.

             This message may also be caused by another situation: A TSR could
             be interfering with your system and its ability to read the
             original file from disk.

             Programs known to cause PATCH.EXE to generate this error are
             Stacker and DoubleSpace, some disk caches, some CD-ROM drivers,
             and some anti-viral software. Anything loaded in your CONFIG.SYS
             and AUTOEXEC.BAT can potentially cause this error. Each can cause
             the checksum of the file you have to differ from the checksum of
             the file we used to build the patch.

             Please try to remove these items from memory if PATCH gives you
             this error, and then start over at step 2.  The best way to do
             this is to boot from a bootable floppy drive that has NO
             CONFIG.SYS or AUTOEXEC.BAT.

             If all the above steps fail, please upload your TELIX.EXE file
             to deltaComm Online at 919-481-9399 and we will look into the
             possibility of adding support to the patch for your revision.

------------------------------------------------------------------------------
