MODIFICATION OF "BEST MOUSE" FOR USE WITH A MOUSE PAD.

     This  modification  is  not  authorized  by Best Electronics. Any
damage  to  the  mouse or it's parts due to inept craftsmanship is not
my, nor Best Electronic's responsibility. It works for me, and it will
work for you. If you take your time.

     "BEST  MOUSE"  is  a  replacement  mouse  for  the  ST from "BEST
ELECTRONICS."  It surpasses the ST mouse by a hundred fold. The shape,
rounded edges and top, is designed for total comfort. It fits right in
the palm of your hand. The buttons are tight, silent, and precise. The
cord  is  longer  and  more  flexable. And all internal parts are user
serviceable,  available  from Best Electronics 2021 Alameda Suite 290,
San Jose, Ca. 95126. Phone# (408) 243-6950. All things considered this
mouse  is  a  dream  come  true  for  any  ST  user.  (EXCEPT  FOR ONE
THING!!!!!).  This mouse does not like mouse pads. The kind with a 1/4
inch   foam rubber backing and nylon surface anyway. It has a tendency
to  rock, and for some unknown reason it doesn't glide smoothly on the
pad.  These  problems  only happen when you use a mouse pad. I however
like mouse pads, so I set out to fix this annoying design flaw.

     First,  the  rocking.  The  Best  Mouse  only  has (3) feet. So I
figured  to  stop the rocking I could add (2) more feet. I just called
Best  Electronics  and  ordered  a set of (3) teflon replacement feet.
Actually  I  had  to order 2 sets because the minimum order was $5.00.
One set cost $3.00. When they came I just peeled off the paper backing
and stuck them on, and no more rocking. That was easy.

     Second,  getting  it  to  move  more freely on a mouse pad. After
close  examination with a straight edge and a flash light, the problem
was  clear. The door on the bottom that lets you insert the mouse ball
sticks  out too far. And when the weight of your hand is on the mouse,
that  door drags on the pad making it real sluggish. An obvious design
flaw.  I  took the door off and proceeded to sand it down (on the side
that  faces me). I used #120 grit paper. This took a while, even using
a belt sander. "A NOTE OF CAUTION.") (Although this piece is made from
high  quality plastic there are small tabs on it that can, if your not
careful, break off. So handle it with care. And if you use an electric
belt  sander  to  sand  this  door,  only apply gentle pressure to the
piece.  It  gets warm fast.) Every once in a while check your progress
by thoroughly cleaning any dust from the door and testing the fit. The
object  is  to  get the door flush with the bottom of the mouse. After
you  get  the  door  to your liking, reassemble it and check it out. I
think you'll be very happy with the result.

     Oh!  by  the  way,  I'm not sure, but I think the sanding part of
this  mod.  could  void your 90 day warranty. Not that you'll need it.
"This mouse is built to last!"


                           Mark Bombard

                           Flying Monkey Studios