-------------------------------------------------------------------------
                    PRINTER & PATHS SUBMENU Commands
-------------------------------------------------------------------------

SET CATALOG PATH [C]:
    Using the Fileselector, specify the path where you'll be saving your
Catalog files.  By specifying a file mask you can show only files that
are Catalogs.  Example:  You'll be storing catalogs in the CATALOG
directory on drive D: so you'd locate that path with the file selector
(D:\CATALOG\).   Then you could specify to show only files with the .CAT
extension by entering *.CAT on the file name line.  Select OK to accept
the setting.

SET COPY FROM PATH [F]:
    Set this path the same way as you would for Set Catalog Path.  This
is the path that will be the default for the source file location for the
Copy Files command.  Also, this will be the default for the View Text
File command.

SET COPY TO PATH [T]:
    Same as the Set Copy From Path except this is the default path for
the Destination of the Copy Files command.

PRINTER SETUP [P]:
    To take advantage of your printer and to make sure TAC-CAT Librarian
is speaking the same language, you may need to specify certain printer
commands.  You will need to refer to your printer manual for the needed
printer control codes.  

SAVE/LOAD PRINTER [S]:
    You can create a printer setup file that can be loaded at will.  For
instance, you may have two printers.  Create a printer setup for one and
then save it using the Save/Load Printer command.  Then change the
printer settings to match your second printer and save it under a
different filename.  Then, when you switch to a different printer, simply
load that printer setup file.  Printer setup files have ".PRT" as their
extension.


