************************************
* ATTENTION! ATTENTION! ATTENTION! *
* You MUST read this otherwise     *
* your monitor could be destroyed! *
************************************

BlowUP030 Demoversion

This demo may be copied and passed to
others for free as long as all the
files, espacially this README remain
unchanged!

BlowUP030 (c) Georg Acher & Michael Eberl
=========================================

Warning:
--------
IF YOU HAVE A FIXED-FREQUENCIE MONITOR
(E.G. A VGA OR SVGA) NEVER SELECT THE
'MS1/2' BUTTON IN BLOWCONF.PRG!!!!!
ONLY IF YOU LEAVE THIS BUTTON UN-
SELECTED IT IS ENSURED THAT YOUR
MONITOR WON'T GET HORIZONTAL-
FREQUENCIES THAT MIGHT DAMAGE IT!


Short-Manual for the BlowUP030-Demo:
------------------------------------

Run BLOWCONF.PRG (the demo runs only in
16 colors and with the ATARI-VGA-
adapter installed) and choose the
monitor-type you are using:
 VGA:   fixed frequencies of
        31.5kHz/60Hz
 SVGA:  fixed frequencies of
        31.5/35.5kHz /60Hz
 MS1/2: multiscans, e.g.
        15-38kHz/30-55kHz at 50-100Hz

Only with a multiscan you are able to
configure your resulution live, because
they are able to display all values in
a certain range. for VGA/SVGA this
might be very dangerous.

*
*  All chnges can be returned to their
*  original value with UNDO (or the
*  return-key)
*

LOAD CONF:  displays a list of
     predefined resolutins. In this
     list you find the monitor-type it
     is suitable for. Select one and
     confir with OK to install the
     resolution.
SAVE: The resolution that is configured
     at the moment is saved into the
     'BLOWBOOT.PRG' file in the
     AUTO-folder of your boot-device
     (usually C:).

*  ATTENTION:
*
*  BLOWBOOT.PRG has to be the last
*  programm in the AUTO-folder
*  (especially behind MultiTOS and
*  NVDI). Select unsorted in the
*  DESKTOP-menu to be sure

After the next RESET the new resolution
will be used if you boot in 16 colors.
If you do not, use the DESKTOP-menu
to switch to 16 colors.

The special ability of the
BlowUP030-system is that you are able
to configure the video-parameters very
free. Vertical and horizontal
Screen-position, left, right, upper and
lower margin, interlace-mode and
pixel-clock might be set freely (in
certain margins given by the
Falcon-hardware) TO TAKE OUT THE BEST
OF YOUR MONITOR.
If you have a multiscan and selected
then MS1/2-mode you are able to find
the maximum - step-by-step.

With BLOWCONF you are able to install
two resolutions for every color-depth.
BLOWACC enables you to select which one
or even if one of the new resolutions
is used.

The SCREEN-SAVER is the newest feauture
of BlowUP030:
If it is active it speeds up the Falcon
at up to 70% (depending on the
Color-mode and resolution).