ROCKFILL, written for NASA Marshall Space Flight Center, is a software
package that calculates key robot weld information. Its easy to use menu
system allows the robot operator to better estimate the number of passes,
amount of wire, estimated arc time and the estimated amount of heat that
will be put into the particular weld. The software is designed to operate
on the robot's work cell PC and requires no documentation or training.
ROCKFILL is intended for use as a shop aid in the Rocketdyne robotic
welding effort, and is not a tool for design. The program assumes that the
welding process is the Gas Tungsten (pulsed/nonpulsed) Arc Welding (GTAW),
commonly referred to as Tig welding.

ROCKFILL, MFS-29716, is written in C Language for IBM PC and compatible
computers running MS-DOS. The source code will only compile properly with
the Aztec C v3.2 compiler; however, an executable is provided on the
distribution disk. The standard distribution medium for this program is
one 5.25 inch 360K MS-DOS format diskette. Some documentation is
available, showing the basic menu screens, but ROCKFILL is intended as a
stand alone program. Program $150; documentation $12.

COSMIC, The University of Georgia
382 East Broad St, Athens, GA 30602-4272
706-542-3265

  +---------------------------------------------------------------+
  |   From the America Online New Product Information Services    |
  +===============================================================+
  | This information was processed with OmniPage Professional OCR |
  | software (from Caere Corp) & a Canon IX-30 scanner from data  |
  | provided by the above mentioned company. For additional info, |
  | contact the company at the address or phone# indicated above. |
  |    All submissions for this service should be addressed to    |
  |   BAKER ENTERPRISES, 20 Ferro Drive, Sewell, NJ 08080 U.S.A.  |
  +---------------------------------------------------------------+
