                ****   What's New In Microqwk   ****


Microqwk ver 1.5a
August 9, 1994


 SFNET routed Mail
        MicroQwk allows SFNET routed mail when sending and replying
to a SFNET message. 

 Formatted Replies
Formatted Output on replies is available from the Configuration
Menu.  If you toggle formatted output on, you will be asked for
the line length for your output and for the length to break for
a paragraph.  MicroQwk defaults to 70 character line length and
58 for break length.  You may also change these format parameters
from Qwk Mail by pressing ALT - F6.
Microqwk will not format commented text but will reproduce those
lines without break.

 New Positioning Commands

   CtrlLeft Arrow           Go To Last Read message
   CtrlRight Arrow          Go To First Unread message
   Home                      Go To the First Message in the Conference
   End                       Go To the Last Message in the Conference
               
 New Updating Qwk Packet and Reply commands

   F10             Update and Save Reply Packet
   AltF10         Update Qwk Packet and Reply Packet



MicroQwk now supports the creation of an .SDR (Spitfire Deletion Record)
file.  Previous versions of MicroQwk and Lakota were limited to the deletion
of a message in the users message queue if that message was being replied to.
MicroQwk now can tag messages that you wish to delete from your message
queue, but are not important enough to reply to.  Pressing F8 toggles the
inclusion of that message in the .SDR file that is included in the reply
packet sent to the Spitfire board.  Lakota will then process this file
when the packet is unzipped and read.
With this feature it was also necessary to change the internal record keeping
on the status of each message, so as an addition several improvments were made
in their display while in the Qwk Mail viewer.

Pressing F8 while in QWK mail will toggle the Delete Unreplied Message.
A message that you have deleted when replying to that message will not
be affected by pressing F8.

A small bit of code was added that allows MicroQwk to be run from the Dos
Path statement.



NOTE :
If you have a copy of Microqwk previous to version 1.2b, you should
re-configure and save your new configuration before attempting to run
this version !

