    Printing Summaries                                   FILE: OP.HLP 

    Once you have entered the golfing results, the summary reports can 
    be  routed to one of three destinations:                                    
     
    LPT1 - This is the primary parallel printer.  If you have only one      
    printer connected to your computer, then this is the one.               
                                                                            
    LPT2 - Some people have two printers connected to a single machine 
    so   that dot matrix and daisy wheel/laser quality can both be 
    accessed.     You will have to know which one is which but simple 
    trial and error can aide in this discovery.  If you see a DOS 
    message that says something to the effect of "Device unavailable or 
    not ready" it means that you've chosen the wrong one.
                                                                           
    DISK - A formatted disk file is also available for reports.  This is   
    the one that should be used if you're just running intermediate 
    reports and you don't want to waste the paper.   In some cases, 
    there may not  be a 132 column printer available.  A disk file will 
    allow you to run  the report and then review it with a word 
    processor.                   
                                                                           
    SERIAL - If you have a serial printer connected to COM1 or COM2, use   
    the DOS MODE command to reroute the data.  eg. MODE LPT1:=COM1         

