INSTALLATION
          ------------

          1)  Place the Point & Shoot program disk in floppy drive A:

          2)  From the ROOT DIRECTORY of your hard disk, type:

                               A:INSTALL

          3)  Add "P&S" to the PATH command in your AUTOEXEC.BAT file.
              If you don't have a PATH command in your AUTOEXEC.BAT
              file, then make the following the first line in your
              AUTOEXEC.BAT file:

                               PATH \P&S

          4)  Add the command  PS  (not  PAS ) to the END of your
              AUTOEXEC.BAT file.

          5)  Make sure your CONFIG.SYS file contains the following lines:

                               FILES = 20
                               BUFFERS = 20

          6)  Reboot your computer (Ctrl-Alt-Del).  Point & Shoot
              should appear on your screen.  If any problems occur,
              consult the documentation.


       COMPATIBILITY PROBLEMS
       ----------------------

       NOTE:  Compatibility problems have been reported with certain
              models of computers.  Point & Shoot may not run
              correctly on the following computers:

                -  AT&T 6300 with CGA monitor
                -  HP Vectra with monochrome monitor (early models)
                -  Some Compaq models with EGA monochrome monitor (these
                      may work correctly if you add a MODE MONO command to
                      the PS.BAT file immediately before the PAS command)

                - DO NOT use the screen blankers (ASB & ASBE) with IBM PS/2
                      computers.  Some users have reported that PS/2's will
                      hang if the screen blankers are used.

              If you experience problems with your computer, please report
              the problem to AMST.


          PRINTING THE DOCUMENTATION
          --------------------------

          To print the documentation, type the following from the DOS
          prompt:

                         COPY  PASDOC.TXT  PRN:

          A second option to print the documentation is to use the File
          Print command found in the Point & Shoot file commands.


          RESTARTING POINT & SHOOT FROM DOS
          ---------------------------------

          To restart Point & Shoot from any directory, type:  PS

          If the current drive is other than the drive containing Point &
          Shoot, then change to the correct drive first.