Lightwave Communications

                                  Release 1.0

                Copyright 1986 by Lightwave all rights reserved.
         
         
         THIS SYSTEM IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, 
         EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO THE 
         IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A 
         PARTICULAR PURPOSE.  THE ENTIRE RISK AS TO THE QUALITY AND 
         PERFORMANCE OF THIS SYSTEM IS WITH YOU.  SHOULD THE SYSTEM 
         PROVE DEFECTIVE, YOU (AND NOT LIGHTWAVE) ASSUME THE ENTIRE 
         COST OF ALL NECESSARY SERVICING, REPAIR AND CORRECTION. 

         This file may only be distributed as one file on the Lightwave 
         Communications distribution diskette.  Such duplication and 
         distribution is authorized without compensation as long as the 
         diskette is a duplicate of the Lightwave Communications 
         distribution diskette.  This file may also be distributed in 
         printed form as long as a copy of the distribution diskette is 
         attached.  All other distribution is strictly prohibited. 
         
         Lightwave suggests that you make a copy of the distribution 
         diskette before you get started.  Lightwave Communications may 
         only be distributed if the diskette is a duplicate of the 
         distribution diskette. 
         
         You can use either the DOS COPY or DISKCOPY command to copy 
         the distribution diskette.  Lightwave Communications is 
         perfectly at home in hard disk systems. 
         
         There are currently two systems that comprise Lightwave 
         Communications.  SUPERCOM is an asynchronous communications 
         package that supports many aspects of PC communications.  
         DIALER is an electronic phone dialer.  Both are included on 
         this diskette.
         
         The manual for Lightwave Communications, which covers both 
         SUPERCOM and DIALER is called MANUAL.  You may use the DOS 
         PRINT command to print this manual.  The manual will provide 
         you with all the information you need to run each system. 
         
         You will need to configure SUPERCOM for your particular 
         computer before using that system.  The manual provides the 
         information necessary to complete this configuration. 

         The definition of the distribution diskette is a diskette 
         that is an exact duplicate of the diskette as it is shipped 
         from Lightwave.  You can test the accuracy of your diskette 
         by entering the command:  CHECK *.* at the DOS prompt.  The 
         output from the CHECK program must exactly match the 
         information in the file CHECK.TXT, excluding the CRC for 
         CHECK.TXT and the total. 
         
         The above test will tell you if you have a damaged or 
         incorrect disk.  The CHECK program is distributed with all of 
         Lightwave's products, and it calculates the CRC of the named 
         file(s).