SMCap

                       Written By CMH Electronics

                               March 1994


Introduction

SMCap is a small program that is intended to mimic some of the
actions of Novell's capture.  SMCap was designed to allow access to
Novell's print spooling redirector.  In particular, SMCap will more
readily allow you to  direct your printouts to the queue of your
choice from within an application.  Because SMCap is about 140KB
smaller than capture, it has a better chance of being successfully
executed from within a large program.


Running SMCap

To use SMCap enter

    SMCAP lpt# queuename

 from the command line. "lpt#" is the number of the printer port which
you wish to redirect, and "queuename" is the name of the queue to
which you wish to redirect it.

Notes

At this time the queue must be described in the bindery on the default
server.  There is no endcap facility; Novell's endcap is quite small.
There is however an implicit endcap when you select a new queue.  This
program has been tested only on Novell 3.10 and 3.12.


Shareware Concept

SMCap is our first attempt to offer a program under the shareware 
concept.  If you like this program and find it useful we request
that you contribute to the development of this and similar programs
by sending $5.00 to our address below.

                            CMH ELECTRONICS
                          134 HILLCREST AVE NW
                         NORTH CANTON, OH  44720



Novell is a registered trademark of Novell, Inc.