-------------------------------------------------------------------------------
                               LanMap v2.3x
                                DEMO DISK

  Please read the entire file called LANMAP.DOC.  This file contains a
  detailed installation procedure and the complete User's Manual for LanMap.

  It is suggested that you print the LANMAP.DOC file.

  We assume throughout that the user is a Network System Administrator and
  is therefore well versed in PC/DOS and Netware.  The User's Manual is
  quite specific in its directions about the use of LanMap, but does not
  get into unnecessary detail about how to map Netware drives or how to use
  DOS commands.  If you have trouble with any of these procedures, please
  refer to your Netware and DOS manuals respectively.  If you have, after
  reading the LANMAP.DOC file, unanswered questions about the operation
  of LanMap, please feel free to call your distributor or:

                       Computer Communication Co.
                       151 New Park Ave.
                       Hartford, CT 06106
                       Phone: 1 (800) NET-LOCK


  This demonstration disk of LanMap is limited in several ways.  First, it
  only allows for 3 workstations instead of 255.  Second, it only sees
  two file servers instead of 8.  Third, it only allows maps to be 24 lines
  (one screen) instead of 250 lines.  In all other aspects the Demo version
  of LanMap functions just like the full version.

-------------------------------------------------------------------------------

                      How to Install LANMAP

   LANMAP can be installed on any hard disk, floppy disk, or
network drive by using the normal DOS COPY command, or the
Netware equivalent NCOPY command.  The following set of
instructions will install LANMAP under the PUBLIC subdirectory.
Here we are assuming that SYS:PUBLIC is mapped to the Z: drive,
as this is the default mapping for Netware.  If this is not the
case, or you do not wish to install LANMAP in the PUBLIC
directory, then simply substitute the appropriate drive letter
for your case.

1)  Make SYS:PUBLIC the default drive.  Type Z:

2)  Copy the LANMAP files into PUBLIC.  Type NCOPY A:*.* Z:*.*

3)  Make LANMAP a read-only file.  Type FLAG Z:LANMAPD.COM SRO

4)  Make NETLIST a read-only file.  Type FLAG Z:NETLIST.COM SRO

  The LANMAP files are now installed in the PUBLIC directory.

-------------------------------------------------------------------------------