SECTION 4. HARDWARE INSTALLATION PROCEDURE

4.1 - Adapter Installation
To install the MEGAVISION 3D & TV-OUT Graphics Adapter into your system, please follow these steps:

• 1. TURN OFF all POWER to your system, including any peripherals (printer, external drives, modem, etc.).
• 2. UNFASTEN the cover mounting screws on your system. Refer your system user manual to determine the location of the mounting screws.
• 3. OPEN the system cover. Refer your system user manual for instructions on how to remove the system cover.
• 4. SELECT an appropriate (unused) PCI Bus expansion slot for the MEGAVISION 3D & TV-OUT Graphics Adapter. Please refer to your computer system manual for the location of the PCI Bus expansion slot. REMOVE the retaining screw that holds the slot cover in place. SLIDE the slot cover out and keep this screw handy.
• 5. Alternatively, if you are REPLACING AN EXISTING GRAPHICS ADAPTER with the MEGAVISION 3D & TV-OUT Graphics Adapter, carefully remove the screw to your existing adapter and remove the old/existing adapter from your system.
• 6. INSTALL the card. To install the MEGAVISION 3D & TV-OUT Graphics Adapter in the selected PCI Bus expansion slot, align the gold-fingered edge-connector of the card directly above the selected expansion slot on the motherboard, then gently but firmly insert the adapter fully into the slot.
• 7. SECURE the MEGAVISION 3D & TV-OUT Graphics Adapter. Use the screw you removed from the expansion slot in Step 4 to secure the card in place.
• 8. CLOSE the computer cover. Secure the cover with the mounting screws removed in Step 2.

You have now completed the installation of your new MEGAVISION 3D & TV-OUT Graphics Adapter into your system. Before you use the system, however, please refer to the following section.

4.2 - Connection to a VGA Monitor
The MEGAVISION 3D & TV-OUT Graphics Adapter is provided with a 15 pin analog connector. When you connect your monitor to the VGA Card , ensure you have the right cable and cable connector. Fixed-frequency analog monitors come equipped with a 15 pin connector. Variable frequency analog or analog / digital monitors will require a 9-to-15 pin cable adapter.

4.3 - Connection to a TV
The MEGAVISION 3D & TV-OUT Graphics Adapter is provided with an S-Video jack and a Composite (RCA) jack for connecting to a PAL or NTSC TV. You can use either type of jack for connection to a TV, however the S-Video jack will provide a higher quality signal.

Note : Cables for connection to a TV are not included with this package, as these cables are usually supplied with your TV set. If not, then they can be easily purchased through most consumer electronic stores. The two types of cable are as follows.

COMPOSITE CABLE - This type of cable is commonly used to connect your TV set to the aerial outlet or VCR output. For the MEGAVISION 3D & TV-OUT Graphics Adapter a 'male' connection is required, and usually the input to your TV will also be 'male'

S-VIDEO CABLE - This cable is a higher quality 4-pin cable which is suitable for modern day TV's and VCR's. Using this type of cable will provide a higher quality signal.

4.4 - Sega 3D Games
The MEGAVISION 3D & TV-OUT Graphics Adapter is bundled with Sega 3D Games (optional) - Virtual Fighters, Daytona Racing & Virtual Cop.

Return