                     NE1000/NE2000 NDIS PROTOCOL.INI User Manual



          
          This document describes the PROTOCOL.INI keywords used for the
          Microsoft NE1000/NE2000 NDIS device driver v0.31.
          
          IOBASE - This keyword describes the IO base address used by the
          adapter. It must match the jumper settings as described in the
          installation manual. The values of IOBASE range from 200H to 3E0H
          in increments of 10H. If multiple adapters are installed, the
          IOBASE values must be at least 20H apart. The IOBASE default is
          300H.
          
          INTERRUPT - This keyword describes the interrupt used by the
          adapter. No other device installed in the computer may use this
          interrupt. It's value must match the jumper setting as described
          in the installation manual. INTERRUPT can range from 2 to 5
          inclusive, the default is 3.
          
          DRIVERNAME - This keyword describes the device driver's name. The
          default is MS1000$ if NE1000, or MS2000$ if NE2000. If more then
          one adapter is installed, the device driver names increment as
          follows:
          
              MS10002$, MS10003$, MS10004$, ..., MS10009$
              
          Following is an example PROTOCOL.INI fragment:
          
              [NE1000_NIF]
                  Drivername = MS1000$
                  Interrupt = 3
                  IoBase = 0x300
              
              [NE2000_NIF]
                  Drivername = MS2000$
                  Interrupt = 3
                  IoBase = 0x300
              














                               DWB Associates 7/27/90
