                                    ADDING

    To  ADD a group of numbers you must first mark >     $1,111.11
    the  area to be summed.   Only one number  per         <555.55>
    line should appear in the marked area.  In the        3,333.33
    example to the right,  place the cursor to the         <666.66>
    right  of the '>'  character and press  CtrlB.         <444.44>
    Place  the cursor to the left of the '<'   and        2,222.22
    press  CtrlB again.   The area to be summed is        7,777.77
    now  marked.   Now hold down the Ctrl key  and        8,888.88       <
    press 'A'.   Note that the answer is placed in
    an  inserted line below the last number to  be
    summed.

    It is not necessary for the numbers to be aligned.  For example, you
    could have positive numbers to the left and negative numbers to the
    right.
                              Press the PgDn Key

    You may use the minus sign if you prefer to indicate negative numbers.

    If the default monetary symbol is found in any number, it will appear
    in the answer.  If the default thousands separator is found in any
    number and the result is greater than 999, it will be used in the
    answer.  If it is not encountered in any number, it will not be used
    in the answer.  Similarly, the default symbol used to separate the
    whole number from the fractional part will not appear in the result
    if it was not encountered in any of the numbers defined in the sum.

    Mark  the  block to the right as you  did >     111.111
    above  with  CtrlB's.    If  you  do  not       222.222
    remember  Ctrl  A is for adding  numbers,                  -333.333
    Press  F7  for  Blocked  area  functions.       444.444
    From this menu you can either press F8 or                  -555.555  <
    Ctrl A to perform the sum.

             Press PgDn to see how to set Default Sum Characters

    CHANGING THE DEFAULT SUM CHARACTERS

    (Read the following BEFORE trying it.)

   By pressing F8, the Miscellaneous key, you will see that defaults can
   be modified by pressing F2.  When you do this you will be presented
   with a menu of defaults which may be changed.  To EXIT from this menu
   of defaults, all you have to do is press the Esc key.

    Now press F8, then F2, look at the Menu and then press the Esc key.

    Toward the bottom of the menu, the field "Default Sum Characters"
    is visible.  This time when you go to the menu, Tab (or Shift Tab) to
    this field and press F10.  (NOTE: you should answer NO to the question
    "Save Modifications" when you escape from the menu panel this time.)

    After pressing F10, AltG will let you select new default characters.

                     Press F4 to return to the HELP Menu


