Wildcat and Windows 3.0
 
I have been running Wildcat 2.15s under Windows 3.0 for about two weeks now and it is a dynamite combination.  I had tried Wildcat and Deskview without a lot of success.  I have included the PIF file that I created for CAT.BAT and it works fine!  I am currently running an IBM PS/2 Mod 55SX with 7 Meg of RAM and a 60 Meg fixed disk.  I am using a US Robotics 14400 HST modem.  There are some additional setup steps that you must take to support hi-speed modems. 
   1.  You must insure that these two lines are set up in
       your SYSTEM.INI file:
          COM1Buffer=256
          COM1Protocol=
   2.  Use the  Control Panel - Ports option to set the com1 
       speed to 9600.
These steps are necessary in order to not drop data when running under windows.  You probably also want to insure the hi-speed comm applications run at a higher priority than other applications under Windows.


                              Chuck  Moorhead
         				    The Wild Side BBS
					    703-351-9440