TAPMARK (v1.43) by Korenthal Associates          REGISTRATION ($25.00)

TAPMARK is an intelligent thread marking program to be used instead of
the TAPCIS "M" command.  If  used properly, TAPMARK can save  you gobs
of time and enhance  your enjoyment of CIS  and TAPCIS.

The full value of TAPMARK cannot  be realized unless it is run  for at
least  three  or  four  CompuServe  sessions,  allowing the program to
accumulate enough information to  be truly useful.  Using  the "Global
preferences"   capability   (to   specify   keywords   of  interest or
non-interest)  will  allow  you  to  derive  additional  benefit  from
TAPMARK.

TAPMARK will save you time by performing the following functions:
   1. Consolidate multiple threads with the same subject name (you only
      have to mark the subject name once).  Note that subject names are
      case-insensitive for consolidation and sorting purposes.
   2. Pre-mark threads which:
        a) contain messages addressed to you (this guarantees
           that you'll see all your messages in context).
        b) you've read in a previous CIS session.
        c) are in a section in which you've expressed interest.
        d) contain a keyword in which you've expressed interest.
   3. Pre-unmark (allow quick bypass of threads) which:
        a) contain only one message to you which TAPCIS has already read.
        b) you've bypassed in a previous CIS session.
        c) contain a keyword in which you've expressed a lack of interest.

TAPMARK will work on a system  which runs any version of TAPCIS.  140K
free memory is required, so if you run TAPMARK by shelling to DOS with
TAPCIS' Ctrl-F1  command, you  should have  at least  400K free before
running  TAPCIS.   If  you  don't  have  400K free, you can always run
TAPMARK  by  exiting  TAPCIS,  running  TAPMARK,  and  then reentering
TAPCIS.