Tseng Laboratories ET6000 PM Display Driver Installation

GAMMA VERSION - Accelerated Driver for OS/2 Warp
August 19, 1996


NOTE 1: This driver is for WARP only! It will NOT work with other
        versions of OS/2.

NOTE 2:  Make sure the volume label name of the floppy diskette
	 is ET6000.  Use the DOS "LABEL" command if needed.

SETTING VGA MODE
----------------

    Your system must be in "VGA" mode prior to installation.

    To restore to VGA mode:

    1. Turn on the computer. If the computer is already on, press
       Ctrl+Alt+Del to restart it.

    2. When a small white box appears in the upper left-hand corner
       of your screen, press Alt+F1.

    3. When the Recovery Choices screen appears, press V



INSTALLING THE ET6000 PM DRIVER
-------------------------------

    When the desktop appears, open a OS/2 Window or a OS/2 Full
    Screen session.

    Change to the "A" drive.

    Insert the diskette into the "A" drive and type:

      "setup [source path:] [target drive:]

    where "source path" is the location of the SETUP.CMD file and
    "target drive:" is the driver letter + ":" of your boot drive.

    Example "setup a: c:"

    The setup program will copy a few files to your hard drive and
    ask you to reboot your machine. Exit from the OS/2 Window or OS/2
    Full Screen and remove the diskette from the drive and reboot
    your machine.


    After the reboot, click the right mouse button on the desktop
    to display the desktop menu.  Click on 'System setup' to open
    the System Setup folder.  Double click on 'Display Driver Install'
    to begin the second phase of the display driver installation.

    Choose Primary Display from the Display Driver Install screen and
    click OK.

    Select Tseng Laboratories ET6000 from the list of supported
    adapters and click OK.

    At the Monitor Configuration/Selection Utility screen

    *Install Using Display Adaptor Utility Program

    Click OK

    At the Monitor Configuration/Selection Utility Location screen
    backspace over the "A:\" and type:

    c:\os2\svga.exe on monitor

    Click OK

    At the SVGA Modes and Refresh rates supported screen type "AUTO"
    and press ENTER

    Insert the driver diskette into the "A" drive

    At the Source Directory screen click INSTALL

    Click OK

    Type Exit to end your OS/2 Window or OS/2 Full Screen session

    Remove the driver disk.

    Shut down and reboot your system.



REGENERATING SVGADATA.PMI
-------------------------

    You may have to regenerate you SVGADATA.PMI file after the
    install is complete.  To do this, either boot to real DOS
    or start a DOS full-screen session.  Go to the OS2
    directory of your OS/2 boot partition and type:

    "SVGA ON DOS"

    The screen will go black for several seconds while the
    utility gathers information about the modes support by your
    adapter.  After it is done, you DOS session will reappear.
    At this point, rename the file SVGADATA.DOS to SVGADATA.PMI
    and reboot you machine.



KNOWN DEFECTS
-------------

    None.
