Send command format:   Sx  tocall @bbs
where x is message type (P=private)
      tocall is destination callsign (without - number)
      @bbs is destination BBS (again without any - number)  [OPTIONAL]
      ---> If @BBS part is omitted then if the station has entered a
           Home BBS (NH command) that BBS will be used. Otherwise the
           tostation callsign will also be used as the @BBS.
Example: S W1XXX @W0YYY
You will next be asked for a title for the message.
After this you type the message, keeping all lines less than 80
characters. When you are done with the message type ^Z or /EX on a
new line.
     Use SB to send bulletins, ST to send traffic, etc. All messages
sent to a specific callsign will be treated as if you used SP (send
private). To make messages to a specific callsign readable by everyone
use SB instead of just S!
HINTS:
When sending any message to a distant destination, put the CITY, STATE
and Postal Code (if known) as the title of the message.
When sending NTS traffic use   ST postalcode @NTSxx (xx is state or province).
Example: ST 44026@NTSOH
