1AESS Common Input Msgs
FM03 Error rate of specified digroup
FM04 Digroup out of frame more than indicated
FM05 Operation or release of the loop terminal relay
FM06 Result of digroup circuit diagnostics
FM07 Carrier group alarm status of specific group
FM08 Carrier group alarm count for digroup
FM09 Hourly report of carrier group alarms
FM10 Public switched digital capacity failure
FM11 PUC counts of carrier group errors
** MAINTENANCE **
MA02 Status requested, print out of MACII scratch pad
MA03 Hourly report of system circuits and units in trouble
MA04 Reports condition of system
MA05 Maintenance interrupt count for last hour
MA06 Scanners,network and signal distributors in trouble
MA07 Successful switch of duplicated unit (program store etc.)
MA08 Excessive error rate of named unit
MA09 Power should not be removed from named unit
MA10 OK to remove paper
MA11 Power manually removed from unit
MA12 Power restored to unit
MA13 Indicates central control active
MA15 Hourly report of # of times interrupt recovery program acted
MA17 Centrex data link power removed
MA21 Reports action taken on MAC-REX command
MA23 4 minute report, emergency action phase triggers are inhibited
** MEMORY **
MN02 List of circuits in trouble in memory
** NETWORK TROUBLE **
NT01 Network frame unable to switch off line after fault detection
NT02 Network path trouble Trunk to Line
NT03 Network path trouble Line to Line
NT04 Network path trouble Trunk to Trunk
NT06 Hourly report of network frames made busy
NT10 Network path failed to restore
** OPERATING SYSTEM STATUS **
OP:APS-0
OP:APSTATUS
OP:CHAN
OP:CISRC Source of critical alarm, automatic every 15 minutes
OP:CSSTATUS Call store status
OP:DUSTATUS Data unit status
OP:ERAPDATA Error analysis database output
OP:INHINT Hourly report of inhibited devices
OP:LIBSTAT List of active library programs
OP:OOSUNITS Units out of service
OP:PSSTATUS Program store status
** PLANT MEASUREMENTS **
PM01 Daily report
PM02 Monthly report
PM03 Response to a request for a specific section of report
PM04 Daily summary of IC/IEC irregularities
** REPORT **
REPT:ADS FUNCTION Reports that a ADS function is about to occur
REPT:ADS FUNCTION DUPLEX FAILED No ADS assigned
REPT:ADS FUNCTION SIMPLEX Only one tape drive is assigned
REPT:ADS FUNCTION STATE CHANGE Change in state of ADS
REPT:ADS PROCEDURAL ERROR You fucked up
REPT:LINE TRBL Too many permanent off hooks, may indicate bad cable
REPT:PROG CONT OFF-NORMAL System programs that are off or on
REPT:RC CENSUS Hourly report on recent changes
REPT:RC SOURCE Recent change system status (RCS=1 means RC Channel inhibited)
** RECENT CHANGE **
RC18 RC message response
** REMOVE **
RMV Removed from service
** RESTORE **
RST Restored to service status
** RINGING AND TONE PLANT **
RT04 Status of monitors
** SOFTWARE AUDIT **
SA01 Call store memory audit results
SA03 Call store memory audit results
** SIGNAL IRREGULARITY **
SIG IRR Blue box detection
SIG IRR INHIBITED Detector off
SIG IRR TRAF Half hour report of traffic data
** TRAFFIC CONDITION **
TC15 Reports overall traffic condition
TL02 Reason test position test was denied
TL03 Same as above
** TRUNK NETWORK **
TN01 Trunk diagnostic found trouble
TN02 Dial tone delay alarm failure
TN04 Trunk diag request from test panel
TN05 Trunk test procedural report or denials
TN06 Trunk state change
TN07 Response to a trunk type and status request
TN08 Failed incoming or outgoing call
TN09 Network relay failures
TN10 Response to TRK-LIST input, usually a request from test position
TN11 Hourly, status of trunk undergoing tests
TN16 Daily summary of precut trunk groups
** TRAFFIC OVERLOAD CONDITION **
TOC01 Serious traffic condition
TOC02 Reports status of less serious overload conditions
** TRANSLATION ** (shows class of service, calling features etc.)
TR01 Translation information, response to VFY-DN
TR03 Translation information, response to VFY-LEN
TR75 Translation information, response to VF:DNSVY
** **
TW02 Dump of octal contents of memory