IC24AT.4 Subject: ICOM IC24AT keyboard command summary This is an attempt to document all of the known key sequences for the ICO IC24AT (144/440MHz dual band hand held). Some key sequences may be common with the IC[2,3,4]SAT, therefore a fewkey seqences fr thoseradios re also on this list. Some ke sequenes requre optins (such as the PL encode/decode board). This is not designed to replace the owners manual, but to summarize the information in one place. Note: Many controls vary depending on the current mode, i.e.: Scan up/down will search frequencies when in VFO mode, and will scan meory channels when in Memory mode. Consult the owners guide for complete iformation. KEY/COMBINATION = Result, action ---------------- ------------------------------------------------------------- 0-9,A,B,C,D,#,* = note: when transmitting these will generate DTMF tones 0-9 = Enter frequency (can also use the VFO knob) A = VFO mode / clear incomplete entry B = Memory mode C = VHF / UHF change D = Call channel * = Step frequency down/scan down # = Step frequency up/scan up MONI = Open squelch and change to input frequency (if not simplex) while button is depressed H/L/DTMF = Select High/Low power, or (while transmitting) send preprogrammed DTMF codes FUNC + 0 = Dial set FUNC + 1 = PL enable (when option is installed) FUNC + 2 = Code squelch [NOT for the IC24AT, IC[2,3,4]SAT option only] FUNC + 3 = Skip memory FUNC + 4 = Duplexoperatin FUNC + 5 = Code [NOT for the IC24AT, IC[2,3,4]SAT option only] FUNC + 6 = Mask freuency CONTINUED IN IC24AT.5 Downloaded From P-80 International Information Systems 304-744-2253