IC02AT.10 7. Carefully apply power to radio and enter the lowest desired frequency. 8. Adjust slug through bottom hole on VCO cover for .5 VDC at VCO test point (just below VCO shield) at lowest desired operating frequency. 9. This completes the modification. A few words of caution: 1. The radio is not type accepted for use in the commercial band. 2. Make sure you reinstall the battery latch correctly on bottom of radio or battery will become permanently locked onto radio. 3. Tighten screws on bottom of radio snuggly. If they loosen while battery is connected you cannot remove the battery. (This has happened to many units and it would be prudent to periodically check these screws to assure their tightness.) ------------------------------------ ***->Be careful not to transmit out-of-band, or accidentally operate on any non-amateur, unless you are authorized to do so. DO NOT JEOPARDIZE YOUR LICENSE! RELAYED BY...N0KGX...GENE Downloaded From P-80 International Information Systems 304-744-2253