How to Build Your Own Underground Television Transmitter Using Commercially Available Parts.

[Group 42 note : While this device may be possible we do not reccomend it. A VCR's output is no where near broadcast quality. Also using broadband amps like this could amplify other signals that could interfear with public service broadcasts and/or do other nasty things.]

Yes, for some time now it has been possible to construct a clandestine television station, which you can operate from your Telecommando Lair, or modify for Mobile Media Guerrilla campaigns.

We have named this device the Snow Box, due to its cool nature, and the snow seen on blank television channels waiting to be commandeered.

To put together a TV station you will need this stuff:

Likely places to get the linear amplifier, connectors and cables is a Ham Radio swapmeet, a Ham club newsletter's classified ads, a Buy-Sell-Trade paper like The Recycler, or at a store specializing in Ham gear. RF modulators are available at specialty video stores, or major VCR dealers.

Setting Up the Transmitter:

Using a VCR with RF out:

[VCR/RF]F----------------------------U[Linear Amp]U------------U[Antenna]
		  weak RF			     Power RF

Using an External RF Modulator:

[VCR]R-------R[RF Modulator]---------U[Linear Amp]U------------U[Antenna]
       video		     weak RF		     Power RF

Diagram Symbols:

U    UHF-connectors (Ham radio)
F    F-connectors   (cable TV)
R    RCA connectors (stereos)
---  coax, cables, wires
[]   devices (name of device in brackets)
<:>  ceramic insulator (the kind with a hole at each end)

Building The Dipole Antenna:

	  wire			      wire
<:>---------------------+<:>+----------------------<:>
			|   |
	   Short coax	|   |
			 [U]	UHF connector

The antenna is set up much like a clothesline with the wires tethered straight out horizontally. The outer insulators are used to isolate the antenna from the tether lines, which should be rope or nylon cords for good results. The inner insulator isolates a gap between the two long wires of the antenna.

The length of the wires used for the antenna is critical. Look up the length in feet for the channel you want to use in the table below & make each of the two long wires that length. As a rule of thumb, a wire half-wave antenna's length in feet is equal to 468 divided by the frequency in MHz.

VHF Television Channel Data

----------------------------------------
  TV	 MHz	  ---carrier---	 antenna
channel range	  video	  sound	 lengths
------- -----	  -----	  -----	 -------
 2	54-60	  55.25	  59.75	 8.47ft
 3	60-66	  61.25	  65.75	 7.64ft
 4	66-72	  67.25	  71.75	 6.95ft
 5	76-82	  77.25	  81.75	 6.05ft
 6	82-88	  83.25	  87.75	 5.62ft
 7     174-180	 175.25	 179.75	 2.67ft
 8     180-186	 181.25	 185.75	 2.58ft
 9     186-192	 187.25	 191.75	 2.49ft
 10    192-198	 193.25	 197.75	 2.42ft
 11    198-204	 199.25	 193.75	 2.34ft
 12    204-210	 205.25	 209.75	 2.28ft
 13    210-216	 211.25	 215.75	 2.21ft
	(All frequencies in MHz)
  (Lengths are for half-wave antennas)

For Further information: Look in the ARRL Handbook published by the American Radio Relay League for detailed plans & theory for antennas, transmitters & linear amplifiers. The info in that book can be used for setting up an underground AM or FM radio station.

Uses for a TV Clandestine Station:

Public Education: Make a videotape of each step in the process of constructing your transmitter. Show this tape in your broadcasts, "For informational purposes only", of course.

Short-burst zipping: From a fixed or mobile base of operation show short snippets of graffiti-like computer graphics, quick subliminal messages, images & suggestions, or brief phreaker manifestos. Commercials are an opportune time to break into TV broadcasts.

Live call-in shows: Using a Cheese Box, or other device for receiving untraceable phone calls and a video camera do a live call-in show. Encourage people to call in using Red, Blue, and other phreaking boxes.

One way to do call ins to your station is to give a phone # of a frend and use AT&T call forwarding to forward to your phone, then use a radio shack phone recorder to send the signal to the input of a tape deck and then run the output of the tape deck to the input of your mixer.

Another way is to give the number of a local phone booth and use CB or other means of transmission to get it back to your booth. Both of these methods can give away your city of origin if someone looks up the are code.

To avoid this you can find a bussiness that has an answering machine on an 800 number and play with your phone, trying different numbers until you crack their playback code, (this is usually two numbers) then have your audience call and leave your messages or a number for you to call them back. Then you call the machine, enter the code number, and get your messages.


HOME | GROUP 42 | DISCLAIMER | HELP
Copyright © 1984-1996, Group 42