UNIDEN CP-5500 Portable

                NAM Type:  EEPROM
            Manufacturer:  UNIDEN
              Programmer:  Keypad
          ESN Prefix DEC:  172
                     HEX:  AC
 ESN, S/N Match Required:  Yes
    Stamped Model Number:  CP-5500
      Number of Channels:  832

    Programming Sequence:  Install fully charged battery
                           Power On
                           Select NAM
                                  NAM 1:  1 + STO + 90
                                  NAM 2:  2 + STO + 90
                           Power Off
                           Press PWR key while holding * and #
                           Continue holding * and # for four seconds
                            "Roam.No Svc.In Use& M" lights will display
                           Release * and # keys
                           Enter sequence 32218591 (within 7 seconds)
                            SID will display
                           Enter Step number, then data for individual
                            parameter
                           Press STO to enter data for each step
                            (ie to enter System ID, press 0+XXXXX+STO)
                           Increment by pressing next step number
 To review parameters press:  RCL + step number
                            + STO (to exit)
                           Press SEND to write NAM information
                           PASS will appear in display if data is valid
                           Press END to exit program mode

Step                  # of Digits
0              System ID:  5    XXXXX + STO
1              Local Use:  1    (0 or 1) + STO
2                MIN Opt:  1    (0 or 1) + STO
3          Mobile Number:  10   XXX-XXX-XXXX + STO
4   Initial Page Channel:  3    [333 or 334] + STO
5        Access Overload:  2    XX + STO
6       Preferred System:  1    [9 (B) or 1 (A)] + STO

Note 1:  Step number will not display when entering mobile number)

7               Group ID:  2    XX + STO
8              Lock Code:  4    XXXX + STO
9          DTMF Duration:  1    0 - 100 ms or
                                1 - Continuous

Press STO after entering Step 9
Press SEND to write data
Press END to exit program mode

        New Program code:  RCL + 70 + Current 4-digit Program Lock
                            Code (Preset 0000) + new 4 digit program
                            code + STO + END
         New Unlock Code:  RCL + 70 + 4 digit program Lock Code
                            (Preset 0000) + SEND + New 4 digit Unlock Code
                            (Preset 0123) + STO + END

           System Select:  X + STO + 8 + 8
                                 X=1  A Only
                                 X=2  B Only
                                 X=3  Home
                                 X=4  Standard AB or BA
                                 X=5  Inverted BA or AB
                                 X=6  System ID (*)

    (*) To set System ID:  CLR + 5 digit System ID + STO + 72

To view current System Select Setting:  RCL + 88