Exploding lightbulbs by The Jolly Roger
Materials needed:
-lightbulb (100w)
-socket (duh...)
-1/4 cup soap chips
-blackpowder! (open some shotgun shells!)
-1/4 cup kerosene orgasoline
-adhesive tape
-lighter or small blowtorch
-glue
Procedure for a simple exploding lightbulb:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
- Drill a small hole in the top of the bulb near the threads!
- Carefully pour the blackpowder into the hole. Use enough so
that it touches the filament!
- Insert into socket as normal (make sure the light is off or
else YOU will be the victim!!)
- Get the hell out!!
Procedure for a Napam Bulb:
~~~~~~~~~~~~~~~~~~~~~~~~~~~
- Heat kerosene/gasoline in a double boiler
- Melt soap chips, stirring slowly.
- Put somewhere and allow to cool
- Heat the threads of the bulb VERY carefully to melt the glue.
Remove threads, slowly drawing out the filament. Do NOT break the
cheap electrical igniters and/or the filament or this won't work!!
- Pour the liquid into the bulb, and slowly lower the filament
back down into the bulb. Make sure the filament is dipped into the
fluid.
- Re-glue the threads back on. Insert it into a socket frequently
used by the victim and get the hell out!!
When the victim flips the switch, he will be in for a BIG surprise!
Have fun! -Jolly Roger-