Copy Command Help Information      *

The Copy command is used to copy a
range of contours' pen numbers into
a holding register.

The Copy command is intended to be
used in conjunction with the Cut and
Paste commands.  These commands can
be used to create complex repeating
patterns in the pens of a project's
contours.

Perform these steps to use the Copy
command:

  1. Click contour "A"'s pen, if
     necessary, to set the current
     contour.

  2. Click the Copy command gadget.

  3. Click contour "B"'s pen.

The pen numbers from contour "A"
through contour "B" are copied into
a holding register.  The number of
contours from "A" through "B" are
also recorded.

Once a pattern is in the holding
register, it can be pasted back into
a range of contours using the Paste
command gadget.