
     README.TXT                                            PC-FasType Build
                           PRODUCT BUILD INSTRUCTIONS
                           ==========================

     This distribution  master was  sent to  you on  a high-capacity floppy
     diskette and  contains an  install/build  program plus three Shareware
     products.    Each  product will fit on a single standard 360kb  5-1/4"
     diskette.   This install program will build a Master Distribution disk
     for each of the three following PC-FasType products:

            PC-FasType/CGA      PC-FasType/MONO      PC-FasType/VGA

     You can  build your  disks directly  from this disk, or - you can copy
     the entire  contents of this disk to a subdirectory on your hard disk.
     You can  then build  your masters  directly to  floppies, or - you can
     build your distribution masters into a separate sub-directory for each
     product on your hard disk, then copy the contents of each to a freshly
     formatted distribution master diskette.

     This distribution  master disk  MUST be  the default  floppy drive  or
     default sub-directory  on your  hard disk  when you  run  the  INSTALL
     program, otherwise it will fail.   The INSTALL program will prompt you
     for the output destination disk or path; the default destination shown
     on the  screen will  be drive  A:  - you can change it to anything you
     want by typing the desired disk or path in the window.

     This install  program will  NOT format floppies for you; make sure you
     have freshly formatted floppies prior to running this program.

     You cannot  build to  drive B:  if this distribution master disk is in
     drive B:  (and the  same goes  for drive  A:).  You can 'diskcopy' the
     entire contents  of this  distribution master  to a  freshly formatted
     High Capacity  1.2mb 5.25"  floppy, then run this install program from
     drive A:.


     Restrictions:
          The following restrictions apply to this Vendor Distribution disk
     only.    Please  read each  product's  VENDOR.DOC  file  for  specific
     distribution restrictions.

     o   You  are  NOT  permitted  under  any  circumstances  to  make  and
     distribute copies of THIS diskette.  This disk is for YOUR USE ONLY to
     build Distribution Masters!

     o   You are  NOT permitted  to alter  the contents of this disk in any
     way.




     INSTALL PROGRAM INFORMATION

          The install program used by Trendtech Corporation is called
     POWERINSTALL and is authored by ASP member William S. Ataras, III.
     It is a shareware program of the highest quality with excellent
     documentation and sample install scripts.  If you're not carrying
     POWERINSTALL in your library but would like to, you can contact the
     author as follows:

     Write:         William S. Ataras, III
                    1125 Balclutha Dr., #K108
                    Foster City, CA 94404
                    408-648-3662

     BBS:           Toad Hall 415-595-2427
                    Leave message to: BILL ATARAS.
                    Look for PINST*.*

     CompuServe:    William Ataras
                    70400,3542
                    GO IBMSYS, Lib 6
                    Scan PINST*.*  lib:all

     PowerInstall is Copyright 1992 by William S. Ataras, III, All Rights
     Reserved

     ----------------------------------------------------------------------
          ** PC-FasType is a trademark of Trendtech Corporation, Inc.
          Copyright 1983-1992 by Trendtech Corporation, Wayne, NJ, USA
                              All Rights Reserved


     README.TXT                                            PC-FasType Build



































