To install the LANDesk Virus Protect 2.1 upgrade onto a 4.x server, do the
following:

If you already have the files on the 4.x server, i.e. you have copied the 
LANDesk Virus Protect 2.0 files from a Netware 3.11 or Netware 3.12 server
onto the Netware 4.x server, read the README.1ST file and follow the 
directions.  There are no special requirements.

NOTE - This version of LANDesk Virus Protect will run on a Netware 4.01
server in BINDERY EMULATION MODE only.  For details on running in
Bindery Emulation Mode, please refer to your Netware manual.
Be sure you have SET BINDERY CONTEXT set at the server console.
-------------------------------------------------------------------------

If you are installing directly onto a 4.x server, do the following:

1)  From your original LANDesk Virus Protect 2.0 NLM/UTILITIES diskette, 
disk #2, copy the LPROTECT.NLM onto the server.  You can place this file 
anywhere on the server.

2)  Create a DISK1 directory.  Copy VP21-1.EXE into that directory.  Explode
the file by running VP21-1.EXE.

3)  Create a DISK2 directory.  Copy VP21-2.EXE into that directory.  Explode
the file by running VP21-2.EXE.

4)  From Windows select FILE|RUN and run SETUP.EXE from the DISK1 directory.

5)  Follow the prompts during the install.  You will be asked to give the 
path to your current NLM.  This is the LPROTECT.NLM from your original 2.0 
disks.

NOTE - You must run the install from the DISK1 and DISK2 directories.
----------------------------------------------------------------------------

NOTE - If you are using a 4.X server and you load the LPROTECT.NLM, you may 
receive the following message at the console:

SERVER-4.00-30:  THIS MODULE IS USING 4 OUTDATED API CALLS.  
YOU SHOULD UPGRADE TO A NEWER MODULE WHEN IT BECOMES AVAILABLE.

This message is informational only; it is not an error.  The API calls being 
referred to are not made in NW 4.01.  The NLM will function properly.
