Welcome to LANDoc v1.1!

This program will help you document your network installation by allowing you to draw your network on-screen, and then entering pertinent information about each node.

Please note that the version you are installing will limit you to a maximum of 5 nodes per network. You must have a valid license file in order to document more nodes.

Before starting LANDoc for the first time, you will have to start Share. To do this, exit Windows, and at the DOS prompt, type the following command:

SHARE /L:500

Start Windows again and LANDoc will be ready to run. It would be advisable to insert this command in your AUTOEXEC.BAT file so that it will be executed automatically each time you start your computer.

Please note that if you are running Windows for Workgroups 3.11, you should have a line in the [386enh] section of your SYSTEM.INI file which reads:

device=vshare.386

If this is the case, you will not need to load Share from the DOS prompt.

Also, for the pop-up calendars to work correctly, the Short Date format used in Windows must be either MDY or DMY. French Canadian settings often use the YMD setting, which will cause problems. To adjust the Short Date settings, access the International section of your Control Panel and change the Date format.

To purchase LANDoc licenses, please see the on-line manual.

Since this is still just version 1.1, there will probably be many suggestions from users. All suggestions will definitely be taken into consideration for future revisions.

Thank-you for trying LANDoc!
