AMTOR Channel Commands

Type any of the following commands on a new line and end with
either (CR/LF) or the + ? sequence (but not both).  If you do not
use the + ? sequence the system will change the direction of the
link for you when it recognizes a valid command. 

H or HELP - Send the help file

CNCN - Cancel whatever is in progress. (Usually a message you are
       entering into the system)
       
LOGIN (your call) - Logs you in
LOGON (your call) - Same as LOGIN

L - List all available messages in the system, not including
    bulletins (see note)
L (number) - As above equal or greater than (number) 
LTO or LM - List all messages to you
LTO (call) - List all messages to (call)
LFM - List all messages from you
LFM (call) - List all messages from (call)
LT - List all NTS messages
LB - List all general interest bulleting (see note)
LB (number) - As above equal or greater than (number) 
LR - List users who have logged on in the past 24 hours 

NTS - List all unforwarded NTS messages

RN or RM - Read all new messages addressed to you 
R (number) - Read message (number)
RH (number) - Read message (number) including routing headers

SP (call) - Send a message to (call), end with NNNN 
SB (name) - Enter a bulletin with (name), end with NNNN 
SB (name) AT (route) BID (bid) - Enter a bulletin with (name) at
            (route) with a bid of (bid)

SP (call) AT (route) - Send a message to (call) to be forwarded
   via (route)
ST (zipcode) AT (NTS statecode) - Send an NTS message (use       
   accepted NTS subject and message format)
 
NNNN - End a message.  Must have been started with SP, SB, or ST. 
   
CANCEL (number) - Cancels message (number) if originated by you

T - Talk to the sysop

I - Information about this ststem

V - Read version number

A - (After seizing the link) Abort a file being received

LOGOUT - Logs you off
LOGOFF - Same as LOGOUT

/// - Anywhere on the line cancels the line (except in messages)

NOTE: The L, and LB commands will only list messages you have not
previously listed.  Follow the command with a number to override
this feature.  Use 0 to list all messages in the category.

Here are some special commands for the expert user:

EXPERT - Toggles the 'EXPERT' mode
ASCII - Toggles the full ascii character set mode.  Do not 
   use this command unless your system is compatible with the full
   ascii protocol.
RI - Reads the MBO's intercept file
RF - Reads the MBO's AMTOR autoforward routing file 
   Note: RI and RF are available to other MBO's only
F - (After seizing the link) Abort a file being received and mark
   it forwarded if it is for you.  (This is for use with          
   duplicate messages.)

