1)  FIND THE TYPE OF CHANGE MACHINE THAT YOU SLIDE IN YOUR BILL LENGTH WISE,
NOT THE TYPE WHERE YOU PUT THE BILL IN A TRAY AND THEN SLIDE THEY TRAY IN!!!
 2)  AFTER FINDING THE RIGHT MACHINE, GET A $1 OR $5 BILL.  START CRUMPLING 
 UPINTO A BALL.  THEN SMOOTH OUT THE BILL, NOW IT SHOULD HAVE A VERY WRINKLY 
 SURFACE.
 3)  NOW THE HARD PART.  YOU MUST TEAR A NOTCH IN THE BILL ON THE LEFT SIDE 
 ABOUT 1/2 INCH BELOW THE LITTLE 1 DOLLAR SYMBOL (SEE FIGURE).
 4)  IF YOU HAVE DONE ALL OF THIS RIGHT THEN TAKE THE BILL AND GO OUT THE 
 MACHINE.  PUT THE BILL IN THE MACHINE AND WAIT.  WHAT SHOULD HAPPEN IS:  
 WHEN YOU PUT YOUR BILL IN THE MACHINE IT THINKS EVERYTHING IS FINE.  WHEN 
 IT GETS TOTHE PART OF THE BILL WITH THE NOTCH CUT OUT, THE MACHINE WILL 
 REJECT THE BILLAND (IF YOU HAVE DONE IT RIGHT) GIVE YOU THE CHANGE AT THE 
 SAME TIME!!! SO, YOU END UP GETTING YOUR BILL BACK, PLUS THE CHANGE!!  IT 
 MIGHT TAKE A LITTLE PRACTICE, BUT ONCE YOU GET THE HANG OF IT, YOU CAN GET 
 A LOT OF MONEY!
 
                  !--------------------------------!
                  !                                !
                  ! (1)         /-------\      (1) !
                  !             !       !          !
                  !             !  ÐIC. !          !
                  ! (1)  /\     \-------/      (1) !
                  !      !!                        !
                  !-----/  \-----------------------!

                         /\------MAKE NOTCH HERE. ABOUT 1/2 " DOWN FROM (1)