This is the installable release of VirusScan for Windows version 2.2.5.

Please follow the appropriate set of instructions below for preparing to
install the product and actually perform the installation.


-------------------------PREPARING FOR INSTALLATION--------------------------


  PLACING FILES ONTO FLOPPY DISKETTES
    To prepare VirusScan for Windows to be installed from floppy diskettes,
    you must first format two floppy diskettes (1.2Mb or greater), labeling
    them as "Disk One" and "Disk Two".  Then, you need to unZIP the contents
    of the DISK1.ZIP file onto the disk you labeled "Disk One".  Next, unZIP
    the contents of the DISK2.ZIP file onto the disk you labeled "Disk Two".


  PLACING FILES ONTO A HARD DRIVE
    To prepare VirusScan for Windows to be installed from a hard drive or
    shared network drive, you must first create a directory (or directories)
    in which you wish to store the files - VirusScan can be installed from
    either a single directory or a set of two directories (representing the
    two separate diskettes).  Next, extract the contents of the DISK1.ZIP
    and DISK2.ZIP files into the single directory, or extract the contents of
    each .ZIP file into the two separate directories.


----------------------------INSTALLING VIRUSSCAN-----------------------------


  INSTALLING FROM FLOPPIES
    DOS
      Insert the diskette you labeled "Disk One" into the A: drive.  Type
      in the following two lines at the command prompt:
        A:  <ENTER>
        INSTALL  <ENTER>
      Follow along with the prompts presented, answering appropriately and
      inserting labeled diskettes as needed.

    WINDOWS
      Within Program Manager, click on the File menu and select the Run
      option.  Type in the following line at the Command Line prompt and
      press the OK button:
        A:\SETUP
      Follow along with the prompts presented, answering appropriately and
      inserting labeled diskettes as needed.


  INSTALLING FROM A HARD DRIVE OR SHARED NETWORK DRIVE
    DOS
      Change to the directory where the DISK1.ZIP files were extracted
      into.  Type in the following line at the command prompt:
        INSTALL  <ENTER>
      Follow along with the prompts presented, answering appropriately and
      entering the location of the files extracted from the DISK2.ZIP file
      if needed.

    WINDOWS
      Within Program Manager, click on the File menu and select the Run
      option.  Press the Browse button and select the Drive and Directory
      where the files from DISK1.ZIP file were extracted to.  Next, highlight
      the SETUP.EXE file from the list of files in the directory and press
      the OK button.  Then, press the OK button in the Run dialog.
      Follow along with the prompts presented, answering appropriately and
      entering the location of the files extracted from the DISK2.ZIP file
      if needed.

