How to create a install disk for ManageWare.
Each ManageWare's Install disk is compressed in a DISKx.exe file
Every DISKx file will create one of the install DISK listed below.

Example:
DISK1.EXE   ManageWare Interpreter (DOS Install Disk 1)
DISK2.EXE   ManageWare Compiler (DOS Install 2 - Developer Version ONLY!)
DISK3.EXE   Visual ManageWare (Windows Install Disk 1)
*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*
To create an install disk you must type:
DISKx -d Destination_Drive -sPassword
Destination_Drive = A: or B: where drive is 1.44 with a formated
                    blank floppy disk in it
Password = Password you have been given from calling HiTecSoft at 602-970-1025
Simply call HiTecSoft to obtain the password.
The EVALUATION copy does NOT have a password and does not need this parameter.

Note that there is a -s before password.
Example:
DISK1 -d A: -sX96YU
You must create an install disk for every DISKx.EXE that you have.
Note! Disk 1 and 2 installs from DOS but disk 3 installs from windows
*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*
When done, you must install the program by running the install.bat on the
floppy disk or refer to your manual for installation instructions. i.e.
Example:
A:INSTALL (Source drive) (Dest. drive that is mapped to proper file server)

Example:
A:INSTALL A: F:

For Visual ManageWare (DISK3), first run windows then from file menu select
RUN then type A:SETUP

*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*
Technical Support
CompuServe GO HiTecSoft
Tel : (602) 970-1025
Fax : (602) 970-6323
