SEMPLOG : Updates
-----------------
V 1.07 : having had bug reports about addresses > 14 characters in length
         I decided to re-write about 50% of SEMPLOG , if you already run
         version 1.06 or earlier you MUST delete the following files

         SEMPSTAT.DAI SEMPSTAT.MON SEMPSTAT.OLD SEMPLOG.GRF

         This is because Semplog now no longer uses ASCII text to store
         it's information , it uses byt and longwords , making the data
         files MUCH smaller and faster to process.

         You MAY want to delete your CALLED and CALLERS lists as the format
         has changed ever so slightly, if you do so then also delete
         SEMPLOG.DAT.

         If an address read in is over 14 characters in length then it is
         truncated to 13 characters and a > is added to the end to signal
         an address which was too long to display.

         If a system sends or recieves over 10 megs of data then the
         display now shows the amount in K instead of bytes.

V 1.06 : One more bug where Semplog thought you had called out and it was
         a point calling in checked and fixed , occoured if you got

         00:05:01 Dialing xxx-xxx-xxx      <- You dialing out
         00:05:03 Ring                     <- incoming ring noticed
         00:05:08 Connect 14400/ARQ/V32    <- Connected incoming call
                                                        ========
         one immediately after the other in the log.

         Semplog definately now catches the incoming file requests.

V 1.05 : Hopefully I have fixed the problem wherby some entries for the
         Nodes you call end up in the Callers log instead of the Called
         list

         Semplog should now notice any incoming file requests and put
         the F flag in the callers list.