I Zoxxon take no responsibility for the use of these items stated
herewithin. This textfile is presented for informational use
only. The comments are added to most of the things i have
attempted. All of the origional authors names have been deleted
for privacy. All telephone numbers have been deleted also in
order to preserve secrecy.

Some articles are from the ill-fated,
  "THE POLICE STATION"   BBS


  Homemade Bombs (Just the way Mom used to make 'em)
Explosive Devices   An anarchist's beginning guide to explosives!
(or how to get back at those neighbors who told you to turn your
stereo down by blowing em up!)

   1.Quickie...   Take organic pool chlorine and mix it with
vegetable shortening and put it someplace you don't like. It
reacts by itself to produce a very noxious white smoke and heat.
*make sure you are not around because the fumes are harmful to
your health.

   2.A pipe bomb (dangerous)   Take a pipe, crimp (closed at one
end) and pack it 3/4 full of paraffin (or any other semi-solid
with about the same basic chemical structure), poke a number of
holes through the length of the paraffin. On top of this put a
very thin steel (or other metal of that sort) wafer, make double
damn sure** that it fits tightly all the way around. On top of
this put some high concentration HCL (or similar acid). Close the
top now, stand it on end (paraffin end down), and get the fuck
away. You should have about 2-5 minutes depending on the
thickness of the wafer. Watch out for shrapnel.

*sure you will..more like 5-30 seconds. better to use a vial on
the bottom ,stand the pipe upright, tie a string around it and
pull from far away.

   3. Snowball...   Take ammonium iodide, flour, & water and form
this into a snowball. Leave this 'snowball' somewhere where it
will do neat stuff when it dries out. (substituting some
magnesium flash powder for some (not all) of that flour helps
things a bit.)

   4.Fire bomb..   Take carbon disulfide and dissolve white
phosphorous in it. Put it in a stoppered bottle and throw it at
something you would like to see on fire. When the CS2 evaporates,
it leaves a film of P on what ever it hits, and it starts a fire
with the solvent vapors.

   5. Light bulb bomb (click...booom!)   Take a light bulb (brass
based preferably so you can solder the wires back when you are
done) Unsolder the two wires that are soldered to the brass (one
at the center of the base and one on the edge). Remove the base,
taking care not to damage the bulb or filament, then take a pair
of needle nosed pliers and snap the glass nipple that is now
exposed. Fill bulb (not completely),via the hole you just made,
with gasoline. Plug hole with silicone or something. Put the base
back on, resolder the wires, screw into light fixture (with power
off of course!), turn on light...booom! *easier to use a
mini-power-drill.
