GrobRot Documentation
---------------------

This program was written By Robert Craeger and Robert Thompson

In the hopes of being able to print GROBS that were too long to fit into 
the 166 dot requirement of the printer, the program below was written.
This program will rotate a GROB and print it vertically on the IR printer
that so many uf us wish we had.

Unfortunately, this program is slow (Not *really* slow but slow
nevertheless)  A future version is planed that will be entirely in
machine-code.

REMARKS:
Remember to set the appropriate modes on your 48 when using
the old printer.  OLDPRT SHOULD NOT BE ENABLED! for the old printer

PSEUDOBENCHMARK:
This program takes approximatly 1.5 Minutes on a 50x63 GROB

BUGS:
This program needs an inane amount of memory to run!
