DOC+--d--FB<  Programing Tandy CT-301 Cellular Telephone By RECON  Caution: This procedure is intended for use by Radio Shack Store personnel only. Do not give this information to a customer or any other outside person. You can program the NAM parameters into the CT-301 using the phone's keypad. The following chart shows the parameters in the order they apper on the display during programming. The chart also provides the parameter abreviations used on the display, the number of digits for each parameter, the possible ranges of each parameter. The security code is set to 12345 at the factory. You are given the option to change the lock code at the end of this procedure. The parameters listed in the YOUR PARAMETER collum are the parameters for the Boise, ID area. ______________________________________________________________________ NAM :Displayed :Number: :Your Parameter :Abbreviation:Digits: Range :Parameter ---------------:------------:------:-----------:---------------------- Home System ID :HO-ld : 5 :00000-32767:00272 ---------------:------------:------:-----------:---------------------- Access Method :ACCESS : 1 :0-1 :1 ---------------:------------:------:-----------:---------------------- Local Control :LOCAL : 1 :0-1 :1 Option : : : : ---------------:------------:------:-----------:---------------------- Phone Number :PhonE n : 10 :0000000000-: : : :9999999999 : ---------------:------------:------:-----------:---------------------- Station Class :CLASS : 2 :00-99 :10 Mark : : : : ---------------:------------:------:-----------:---------------------- Home Paging :PAGE ch : 3 :001-666 :334 Control : : : : ---------------:------------:------:-----------:---------------------- Overload Class :O-LOAd : 2 :00-15 :15 ---------------:------------:------:-----------:---------------------- Group ID :GrouP : 2 :00-15 :15 ---------------:------------:------:-----------:---------------------- Security Code :Sec CodE : 5 :00000-99999: ---------------------------------------------------------------------- To program the phone: 1. Enter [*] 17 [*] 2001 [*] secrity code [*] The first parameter cattegory [HO-ld; for home system identification] appears on the display. 2. Press [SEL] to display the current value for the parameter. 3. While the current value is displayed, enter the correct number on the phone keypad. If the parameter is already correct, proceed dirctly to the next step. If you have problems, see "Programming Hints." 4. Press [SEL] to display the name of the next parameter category. 5. Repeat Steps 2-4 to program each of the parameters. When you press [SEL] the last time (after entering the customer's 5-digit security code), the parameter information is stored and the phone returns to the normal power-on mode. 6. Although the CT-301 automatically selects the preferred system, you still have to set the system priority to A or B, as described in the CT-301's owener's manual. Programming Hints: * If you try to enter a parameter that is out of the listed range or that has fewer than the listed number of digits, a beep sounds. Repeatedly press [CLR] until the display is clear, and enter the correct value. * To check the entered information, re-enter the programming mode and repeatedly press [SEL]. * You can terminate programming at any time by pressing [SEL] [END]. New parameters entered to that point are stored in memory. ---------------------------------------------------------------------  CALL: THE MARLBORO LOONY BIN BBS 1-908-536-6306 2400 - 14,400 BAUD 24 HOURS  Tell them RECON sent ya.  --------------------------------------------------------------------- .______ ._____ ____ | \| \ / ___ \ | | \ | \/ / / | : / : / / /___ .__|____\____/ \________\ 1(410)XXX-XXXX / 16.8 Dual