----------------------------------------------------------------------------
        NEC 700 Programming Info. from NEC technical support 7-25-96
                        Rewrite by Meridian
----------------------------------------------------------------------------

1. If phone power is on, turn off.
2. Turn phone on. wait for the solid blocks to disappear.
3. Enter 157*09#408 FCN RCL 76 RCL #01 RCL #71
        You are now in NAM programming mode
        You can hit the 1, 2, 3, or 4 key to select from the 4 different NAM's.
4. After selecting the NAM you want to program, use the # key to cycle
   through the fields, and program them by entering the correct information
   you must cycle through all fields with the # key and end up back at the
   first screen (where you select the NAM #) for the programming to be
   successfull. When you have programmed your info, and are back at the NAM
   screen, you man continue to the next step.
5. At the NAM selection screen, you can repeat step 4 to program another NAM
   or you may hold down CLR for 2 seconds or so to return to the screen that
   says "TEST MODE". Once you finish programming, and are at test mode,
   enter RCL #02 to reboot the phone and make your changes effective.
Note: At "TEST MODE" you can also enter RCL #24 to display the ESN or #22
      to display the phone version number. the ESN is NOT keypad programmable.