Installation Instructions. ------------------------- <<<<<<<<<<<< Corrected Installation Kit >>>>>>>>>>>>>> To install Go-Moku 2.0 using this installation kit, - copy all the files listed below to floppy disk (A: or B:). - Start SETUP.EXE from your Windows Program Manager. List of required files: gomoku ex_ 21,185 04-09-94 8:15p gomoku hl_ 15,289 04-09-94 8:15p gomoku in_ 386 04-09-94 8:15p gomoku re_ 908 04-09-94 8:15p gomoku tx_ 4,264 04-09-94 11:57p gomoku us_ 57 04-09-94 8:15p install txt 286 11-09-94 11:17p setup exe 15,312 04-09-94 8:15p setup lst 49 11-09-94 11:05p setup1 ex_ 13,706 11-09-94 11:13p setupkit dl_ 3,657 04-09-94 8:15p threed vb_ 33,649 04-09-94 8:15p vbrun300 dl_ 276,684 04-09-94 8:15p ver dl_ 9,696 02-09-95 6:00p 16 file(s) 391,739 bytes Disk with these files is now your installation disk for Go-Moku 2.0. NOTE: In some occasions, if your system has already got the file VER.DLL and if the file has already been used in the current Windows session and somehow the file got a SHARE lock, you may get a Setup Error Message which looks like this: Could not copy A:\VER.DL_ -> C:\WINDOWS\SYSTEM\VER.DLL If this is the case, please try the following: 1. Quit this Windows session 2. Run Windows again 3. Run A:\SETUP.EXE before running anything else If even after this you still can not install Go-Moku, you may rename your C:\WINDOWS\SYSTEM\VER.DLL file to, say, VER1.DLL and try again. Now it should work with 99% confidence. However, if even after this you still get the message, and cannot install Go-Moku 2.0, then please contact me at and report in details what you've done and what kind of message you got. You help is highly appreciated. Konstantin Gredeskoul September 13, 1994