INTERLINK ST Time and Charges Calculator Copyright INTERSECT Software Corp., 1987 Free to all authorized INTERLINK ST Owners This Charge Calculator will only work with INTERLINK ST version 1.74, earlier versions do not create the Call Log History File required by this program. Furthermore, it will only work with 1.74 if call logging has been turned on and at least 1 call has been logged. If you get the message "Cannot Open Log File" when you try to calculate, it means that either you have a version of INTERLINK earlier than 1.74 or, if you have version 1.74, you do not have the log turned on. Operation of the program is very simple. Simply select your Dial file when you are presented with the File Selector. INTERLOG locates the name of your log file from the definition in the dial file. Once the Dial File is loaded simply select the button for the service you wish to calculate, fill in the date ranges if desired (leaving them empty causes all records to be calculated for that service) and enter the amount that the service charges either Hourly or Minutely. If you do enter a date range the calculation will include only those Conncets that occured within and including the specified dates. Both dates do not have to be specified so that an unspecified THRU date will apply all Connects starting with the from date and an unspecified FROM date will apply all Connects ending with the THRU date. The Message "Bad Record" indicates that your log file is corrupted and you should probably select the ABORT option at this point. The Message "Connect without matching Disconnect" simply indicates that. This is usually caused by turning off your machine while still connected or exiting INTERLINK while still connected. The date and time and service of the offending Connect is displayed for your convenience and the Connect is not added into the call count, time or charge amount. You may run this program from the desktop or from within INTERLINK. Trouble free operation with a hard drive can be assured by placing this program in the same Folder as your INTERLINK ST Software. When using a floppy drive you must be sure that your log disk is located in the proper drive (as specified for the log file in Global Setup within INTERLINK) when the calculate button is depressed. 11/30/87 -- Courtesy of INTERSECT Software Corp. 3951 Sawyer Rd. Sarasota, Fl. 33583 1(813)923-8774 ÿp2   ÿs.