  COMMAND SMOOTH
-----------------------------------------------------------------
    Purpose: Smooth objects using a very complicated and slow algorithm
             which produces incredible results.

             SCALE specifies the scale-factor of the spline-tangents,
             a higher value results in a higher bend of the
             interpolated curves.

             The parameter "noHalveSegs" turns off the interpolation of
             difficult sections using splines - the points will be
             created using lines instead 
             (You should try to drag them by hand)

      Usage: SMOOTH(<objectID>,[<scale>],["noHalveSegs"])
   Examples: smooth(1)
             smooth(1,1.4)
             smooth(1,noHalveSegs)
             smooth(1,1.6,noHalveSegs)
      Notes: 1. There is a limit of 72 faces (source-object) for 
                unregistered users
             2. Subgroups and face-colors will be updated correctly, edges
                and points will be merged
             3. This procedure was designed to work with the following 
                settings:
                 SPLINETYPE=CATMULLROM
                 SPLINEENDS=OPEN
                 SPLINESUBDIV=20
                